Short answer: a geogrid reinforces soil, a geotextile separates and filters it, a geocomposite drains water out of it, and a polymeric strap such as Toughstrap reinforces mechanically stabilised earth (MSE) walls. Most road and embankment projects use two or more of them together.
What does each geosynthetic do?
| Product | Main function | Typical road and embankment uses |
|---|---|---|
| PVC coated polyester geogrid | Reinforcement (tensile strength, low creep) | Reinforced soil walls and slopes, embankments on soft ground, basal reinforcement |
| Toughstrap (polymeric strap) | Reinforcement of MSE walls | Flyover and rail over-bridge approach walls, bridge abutments |
| Geotextile (woven / nonwoven) | Separation, filtration, protection | Between subgrade and aggregate, behind drains, under riprap, protecting geomembranes |
| Drainage geocomposite | In-plane drainage with filtration | Behind retaining walls and abutments, under pavements, in cut slopes |
When do you need a geogrid?
When soil has to carry tension it cannot take on its own: steep reinforced slopes, reinforced soil walls, embankments over soft or saturated ground, and platforms that need load spreading. Maruti's PVC coated polyester geogrid uses high-tenacity polyester for high strength and low creep, is designed for a 75–120 year service life, and holds BIS certificates for uniaxial and biaxial grades plus CE certification. Uniaxial grades go in walls and slopes; biaxial grades are used for base stabilisation.
When do you need a soil reinforcement strap?
In MSE walls with precast concrete facing panels, the reinforcement is often a polymeric strap connected to each panel and run back into compacted fill. Maruti Toughstrap uses polyester tendons in a protective polymer sheath, is BIS and CE certified, and is designed for up to 120 years of service life with very low creep.
When do you need a geotextile?
Whenever two different materials must not mix, or water must pass while soil stays put. A geotextile between a soft subgrade and the aggregate layer stops fines pumping up into the pavement, keeping the aggregate drainage-free and strong. Woven geotextiles give higher strength for separation and stabilisation; nonwoven geotextiles give better filtration and cushioning.
When do you need a drainage geocomposite?
Where water builds up behind or under a structure: behind retaining walls and bridge abutments, in cut slopes and under pavements. A geocomposite combines a geonet core that carries the water with a nonwoven geotextile filter, and can often replace a thick granular drainage layer, cutting excavation and material haulage.
How do they work together?
A typical bridge-approach embankment might use a biaxial geogrid or woven geotextile at the base over soft ground, Toughstrap or uniaxial geogrid in the reinforced wall, and a drainage geocomposite behind the wall face. Maruti supplied highway projects such as the 6-laning of Chennai–Thada NH-5 and the Shujalpur Bypass.
Buying geosynthetics in India
Maruti Techno Rubber Pvt. Ltd. has manufactured geosynthetics since 2010 and supplies geogrids, Toughstrap, geotextiles and geocomposites factory-direct across India, including Bihar, West Bengal, Madhya Pradesh, Chennai, Hyderabad and the North East. See our Supply Across India page or request a quote.
